Installation manual. 1. The kit includes the following parts: 1. Remove the upper part of remote controller (Refer to figure 1). Insert a minus screwdriver into the. this operation manual before using the air conditioner. It will tell See also the operation manual included with the indoor unit for details on the. You can read the recommendations in the user guide, the technical guide or the installation guide for DAIKIN BRC1D You’ll find the answers to all your.
|Published (Last):||23 November 2007|
|PDF File Size:||3.50 Mb|
|ePub File Size:||6.79 Mb|
|Price:||Free* [*Free Regsitration Required]|
The PC board is mounted in the upper part of the remote controller.
Permission level function 6. If required, you can limit the user action by restricting the number of operable buttons. Do not directly touch the PC board with your hand. P1 and P2 do not have polarity. Be careful not to damage the board with the minus screwdriver.
BRC1D52 | Daikin
Do not make any settings not given in the table. This operation is unnecessary when setting by group. Remote controller Wood screws Installation manual Wall vrc1d52 Machine screws 1. Refer to figure 5. Remove the upper part of remote controller Refer to figure 1 Insert a minus screwdriver into the slots 1 in the lower part of the remote controller 2 placesand remove the upper part of the remote controller.
Refer to figure 8. During this time the remote controller can not be operated. The switch box and wiring for connection are not included. NOTE When wiring, run the wiring away from the br1d52 supply wiring in order to avoid receiving electric noise external noise.
Be careful not distort the shape of the lower part of remote controller by overtightening mounting screws. Reattach the upper part of the remote controller Be careful not to pinch the wiring when attaching. Setting is carried out in the group mode, however, if the mode number inside the parentheses is selected, indoor units can also be set individually.
Manual BRC1D52 Daikin
First begin fitting from the clips at the bottom. The kit includes the following parts: Set the remote controller manul turning the power supply on.
Wire the indoor unit 1 Refer to figure 6 Mwnual indoor unit 2 lower part of the remote controller 3 upper part of the remote controller 4 wired from the rear 5 wired from the top 6 notch the part for the wiring to pass through with nippers, etc. Refer to the chapter “Field settings”. It’s a community-based project which helps to repair anything.
Long life filter Approx. Refer to figure 4: Connect the terminals on top of the upper part of the remote controller P1, P2and the terminals of the indoor unit P1, P2.
Refer to the instruction manual for each optional accessory. Not displayed if the indoor unit is not equipped with that function. Change setting when ultra-long filter is installed 2 Thermostat sensor in remote controller 3 Spacing time of display time to clean air filter count setting for when the filter sign is not to be displayed 0 15 25 Approx.